Procedure to Configure PB Printer to work through USB Cable
HOLD BOTH STATION1 and STATION2 BUTTONS IN THE PRINTER
- Switch on the printer
- Leave the Buttons
- Insert the paper into the printer
- Automatically Printer will take the paper inside and a message will be printed as follows
STATION 1-CONFIRM STATION 2=SKIP PRESS LOCAL TO CONTINUE
- Press LOCAL and then STATION 1
- The Default Configuration will be printed as follows
MENU : CONFIG Press STATION 1
DRAFT SPEED: NORMAL Press STATION 1
LQ TYPE: NLQ1 Press STATION 1
PAPER WIDTH: FIRST LINE Press STATION 1
BUZZER: Y Press STATION 1
INTERFACE By default SERIAL or COM1 will be there Press STATION2
Till USB is printed and then Press STATION 1
USB EMULATION By default OLIVETTI will be there Press STATION2
Till IBM is printed and then Press STATION 1
PLUG&PLAY: N Press STATION 1
PAP.EDGE DECTEC.: N Press STATION 1
SPECIAL FORMS: N Press STATION 1
PRINT MODE STANDARD Press STATION 1
BIM MODE: MONO Press STATION 1
PNS SELECTIONS: N Press STATION 1
SAVE PARAMETERS Y Press STATION 1
MENU : CONFIG
- Leave the paper in the printer and switch off the printer (Press power button in the PB printer)
- SWITCH ON THE PRINTER
- Automatically the paper will be ejected
- THE SAME METHOD MAY BE USED TO CONFIGURE SERIAL OR COM1 PORT
Post a Comment